• Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.
• Shake the contents well.
• Remove loose dirt and dust in advance with a vacuum, broom or mop, then damp-wipe the surface with LOBA CleanFix or Cleaner. Stubborn dirt or care product residue must be removed in advance by stripping the surface. Please note the relevant product's technical information when doing this.
• Follow the care instructions according to the area of application.
• The application of a maintenance layer can change the properties and/or gloss level. Test certificates for slip resistance and suitability for sports floors must be observed.

Thinner / Mixing

The product is ready for use and must not be reduced!

Application tool / application rate

LOBA trowel, weasel or cloth / 10-30 ml/m² (30-100m²/l). Levelling with LOBASAND NormalPad white, remove excess completely.

Drying time

• Work in sections and level immediately, within 15 minutes at the latest.
• Careful use possible after 4-6 hours.
• Full traffic capability and coverage after 12 hours.

Application:

Preparation

Clean floor thoroughly with LOBA ParkettSoap. If necessary, use a single disc machine and slightly abrasive LOBASAND Specialpads (beige/green).

Application:

Apply the material thinly with a lint-free cloth and completely remove the excess within 15 minutes.
Alternatively, apply the material thinly in sections and over the entire surface with a smoothing trowel. Remove excess within 15 minutes with a single-disc machine and LOBA fleece cloth, then level the entire surface with LOBASAND Normalpad white.

Important information

Keep soaked cloths, pads and other tools in closed containers. Moisten oil in combination with sanding dust, fabric cloths and so on with water or store in a sealable bucket and dispose of in a fire-safe manner, since otherwise there is a risk of self-ignition.