• For professional use only!
• BEFORE USING, READ AND UNDERSTAND ALL LABEL INSTRUCTIONS AND MATERIAL SAFETY DATA SHEETS.
• For technical advice call our Loba-Wakol Technical Service at 1-800.230.6456.
• Recommended conditions are 55°F-80°F/40-75%rH.
• Sand and prepare floors according to NWFA guidelines.
• WARNING! If you scrape, sand, or remove old paint from wood floors, you may release lead dust. Follow local and/or federal requirements for lead removal. Before you start, find out how to protect yourself and others by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.
• ALWAYS PREPARE A SAMPLE OR TEST AREA TO DETERMINE COMPATIBILITY, APPEARANCE, AND DESIRED RESULTS.
• Shake material well before use.
• Do not thin. Do not add water.
• Do not apply at temperatures below 55°F (13°C). Make sure material is at room temperature. Always maintain adequate ventilation during all phases of the coating and drying process.
• Apply evenly at the recommended coverage rate. Avoid streaks, puddles, and lap marks.
• For applications on white oak, the use of EasyPrime is necessary. Allow EasyPrime to cure overnight prior to the application of Hybrid A.T.
• This product is part of the LOBA and Wakol “Connected Systems”. The approved combinations with Wakol wood flooring adhesives may be found in the "Connected Systems Matrix": https://www.loba.de/us/connected-systems/

Application Tool

LOBA roller Microfiber 100-120T-barTrim padLambswoolBrushRoller

Coverage

500-600 square feet per gallon per coat.

Drying time

• Earliest possilbe recoating after 4-6 hours.
• Fully cured after 5 days.
• If there is a delay in drying wait until you can see that the surface is completely dry.

Recommended Procedure for wood floors:

3 Coat application for commercial use:

• Apply Hybrid A.T. (EasyPrime on white oak or Walnut).
• Allow to dry for 4-6 hours . (EasyPrime: 60-90 min).
• Apply Hybrid A.T. .
• Allow to dry for 4-6 hours.
• Intermediate sanding with LOBASAND perforated pad 180 grit (or equivalent) to remove grain raise.
• Vacuum and tack with water dampened towel or LOBA Mop to remove all dust.
• Apply Hybrid A.T..
  

2 Coat application for residential use:

• Apply Hybrid A.T..
• Allow to dry for 4-6 hours.
• Intermediate sanding with LOBASAND perforated pad 180 (or equivalent) to remove grain raise.
• Vacuum floor then tack using a LOBA Mop and a new/clean LOBA microfiber mop pad lightly dampened with water to remove all dust.
• Apply Hybrid A.T..

Suitable product combinations

Suitable product combinations

Primers:

• EasyPrime
• 2K Intensive
  

Stains:

• 2K IntensiveColor
• Stain
  Refer to the Technical Data Sheets for the product.

Screen and Recoat

• Clean floor, abrade with LOBASAND 180 grit perforated pad (or equivalent). Vacuum floor then tack using a LOBA Mop and a new/clean LOBA microfiber mop pad lightly dampened with water to remove all dust.
• Apply finish following instructions.
• Always prepare test areas to determine compatibility, appearance, and desired results.

• Do NOT use on floors finished with UV cured, oxide containing, factory applied finishes.

For professional use only!

Compatibility

When this product is used in combination with other LOBA products the technical information of these products must be followed. Refer to the Technical Data Sheets. LOBA cannot guarantee the suitability of products other than LOBA.