• For professional use only!
• BEFORE USING, READ AND UNDERSTAND ALL LABEL INSTRUCTIONS AND MATERIAL SAFETY DATA SHEETS.
• For technical advice call our Loba-Wakol Technical Service at 1-800.230.6456.
• Recommended conditions are 55°F-80°F/40-75%rH.
• Sand and prepare floors according to NWFA guidelines.
• ALWAYS PREPARE A SAMPLE OR TEST AREA TO DETERMINE COMPATIBILITY, APPEARANCE, AND DESIRED RESULTS.
• Shake material well before use.
• Do not thin. Do not add water.
• Do not apply at temperatures below 55°F (13°C). Make sure material is at room temperature. Always maintain adequate ventilation during all phases of the coating and drying process.
• Apply evenly at the recommended coverage rate. Avoid streaks, puddles, and lap marks.

Drying time

• • The drying time of mixed finishes will increase.
  • A recoating will be possilbe after 6-8 hours.
  • Can be carefully walked on after 6-8 hours.
  • Light wear after 24 hours.
  • Reaches final hardness after approx. 8 days.

Recommended Procedure for wood floors:

• Add Argo only right before the application by shaking or stirring thoroughly. When using 2-component-systems (2K Duo, 2K Supra A.T.) add Argo only AFTER adding hardener to the mass!
• Perform application according to Technical Information of the finish, regard pro-longed drying times.
• 1K finish mixed with LOBA Argo must be applied within 24 hours, 2K finishes within the indicated application time.
• Longer stability is not guaranteed.
  Can be combined with all LOBA water-based finishes and primers. The application properties of the finish, its product combinability, and the drying time remain unchanged. Refer to the Technical Data Sheet of the corresponding finish.

For professional use only!

Compatibility

When this product is used in combination with other LOBA products the technical information of these products must be followed. Refer to the Technical Data Sheets. LOBA cannot guarantee the suitability of products other than LOBA.