• For professional use only!
• BEFORE USING, READ AND UNDERSTAND ALL LABEL INSTRUCTIONS AND MATERIAL SAFETY DATA SHEETS.
• For technical advice call our Loba-Wakol Technical Service at 1-800.230.6456.
• ALWAYS PREPARE A SAMPLE OR TEST AREA TO DETERMINE COMPATIBILITY, APPEARANCE, AND DESIRED RESULTS.
• Do not thin. Do not add water.
• Transfer material to a LOBA coating bucket before applying.
• Optimum climate conditions are 60°F to 80°F (15°C to 25°C), relative humidity 40% to 75%, material temperature 60°F to 80°F (15°C to 25°C).
• Do not apply to surfaces exposed to hot or strong sunlight, as the applied coating may dry too quickly. Do not apply if rain is expected within 3 hours of application.
• If in doubt, create a test area to determine compatibility, adhesion and appearance. The results may vary depending on the type of wood, especially with oily, resinous and chemically pre-treated woods.
• Avoid drips falling on the surface, smooth out any drips immediately with a brush.
• WARNING! If you scrape, sand, or remove old paint from wood floors, you may release lead dust. Follow local and/or federal requirements for lead removal. Before you start, find out how to protect yourself and others by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.

Application Tool

LOBA Oil brush, brush, non-linting cloth

Coverage

105-270 square feet per 2.5l container. The actual material coverage depends on the type of wood, the wood moisture content, and the surface's weathering. An optimized impregnation / protective effect can only be assured if fiber saturation (maximum oil uptake by the wood) is achieved. This state can only be achieved on vertical surface especially (e.g. on wall panels) after multiple applications.

Drying time

• approx. 12 hours.

Preparation:

• Remove any dirt, moss or old paint beforehand if required.
• Newly installed, largely closed-pore timbers are often unable to absorb adequate quantities of oil, so therefore the pores will first have to be "opened". Please find the recommended preparation in our technical information of LOBA DeckDegrayer.
  

Processing:

• Apply LOBA DeckOil evenly using a brush, LOBA Oil brush or non-linting cloth in the direction of the grain.
• Allow the material to penetrate for approximately 30 minutes, completely remove any un-absorbed oil using non-linting cloth. A single-disc machine with LOBASAND SpecialPad beige can be used optionally.
• For wood furniture, especially seating, rub until virtually dry using absorbent towels.
• If necessary, after drying overnight, apply another layer of oil.

Important information

WARNING! SELF-IGNITION:
Store cloths, pads, and other tools contaminated with oil in closed metal container or soak in water immediately after use. Do not leave used rags on jobsite! Do not dispose of with sawdust!For professional use only!

Compatibility

When this product is used in combination with other LOBA products the technical information of these products must be followed. Refer to the Technical Data Sheets. LOBA cannot guarantee the suitability of products other than LOBA or the bond of the existing coating to the substrate.