• BEFORE USING, READ AND UNDERSTAND ALL LABEL INSTRUCTIONS AND MATERIAL SAFETY DATA SHEETS.
• For technical advice call our Loba-Wakol Technical Service at 1-800.230.6456.
• Recommended conditions are 50°F-80°F/40-65%rH.
• ALWAYS PREPARE A SAMPLE OR TEST AREA TO DETERMINE COMPATIBILITY, APPEARANCE, AND DESIRED RESULTS.
• Shake material well before use.
• Do not thin. Do not add water.
• Do not apply at temperatures below 55°F (13°C). Make sure material is at room temperature. Always maintain adequate ventilation during all phases of the coating and drying process.
• Apply evenly at the recommended coverage rate. Avoid streaks, puddles, and lap marks.

Application Tool

Lint free cotton cloth

Coverage

800-1,000 square feet per 1 quart bottle.

Drying time

• • Slightly stressable after 4-6 hours.
  • Fully stressable after 12 hours.

Maintenance Process

For newly installed multi-layer flooring ,

as well as freshly oiled floors, clean the floor thoroughly to remove all dust and grit (sweeping, vacuuming) and apply an even coat of Oil using a lint-free cloth or a sponge, wiping off any excess oil; do not allow the oil to pool or puddle.

For existing floors with moderate wear.

clean thoroughly with LOBA Hardwood FloorCleaner, if necessary prepare the surface using a floor machine fitted with mildly abrasive pads (beige/green). Allow floor to dry completely. Apply Oil.

Floors with more extensive damage

may require treatment with impregnation oil. For more information about such treatment, see the LOBA floor-care instructions for oiled hardwood floors.

For larger areas

the product can be applied using the SprayCleaner method. Spray Oil onto the floor, and buff the entire area using a floor machine fitted with a white pad.

Important information

WARNING! SELF-IGNITION:
Store cloths, pads, and other tools contaminated with oil in closed metal container or soak in water immediately after use. Do not leave used rags on jobsite! Do not dispose of with sawdust!

Compatibility

When this product is used in combination with other LOBA products the technical information of these products must be followed. Refer to the Technical Data Sheets. LOBA cannot guarantee the suitability of products other than LOBA.