• The surface must be professionally sanded. The floor must be dry and free of any old coatings, oil, grease, wax, silicone, sanding dust and other impurities.
• The optimal processing conditions are room temperature +15°C to + 25°C, floor temperature +15°C to +22°C, rel. humidity 40% - 75%, material temperature +18°C - + 25°C, max. wood moisture 12%, sufficiently ventilate working rooms.
• In order to prevent parquet damage, the room temperature should be set to the annual average expected for the use of the product.
• Shake the contents well.
• Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.

Thinner / Mixing

Application tool / application rate

Drying time

• For fine joints, sand after no less than 20 minutes.
• For renovations with extremely large joints, allow to dry overnight.
• Rework with the recommended surface treatment systems after no less than 60 minutes.

Application:

• After the medium sand (e.g. 60 grain) and before the fine sand (e.g. 100 grain).
• Mix the product with the finest wooden sanding dust as possible for the type of wood in question to form a paste-like, silky putty.
• The finer the sawdust used, the easier the putty will be to apply and therefore the better its adhesion to the joint.
• The entire floor is scraped off before the fine sanding stage.
• For larger joints or damage, repeat the process after drying.
• Carefully remove the remainder from the surface.
• Completely sand away (fine sanding) any putty remaining on the surface after drying.
  Tip: A perfect color result is achieved at a mixing ratio of 1:10 by weight (sanding dust content to binder).

Suitable product combinations

Systems suitable for surface treatment:

• All LOBA finish and oil systems.