• Shake the mixture, add the hardener in a ratio of 10:1 and mix in by shaking. If partial quantities are to be mixed, use the LOBA mixing container or weigh the quantities out. Can be used for one hour after mixing.
• Curing is performed using a mobile UV lamp with an output of approx. 3,000 Watt / ozone-free. For full curing, a radiant intensity of at least 300 mJ/cm2 is required, e.g. with the DecoRad® Floormate, at a speed of 8m/min (display 08.0).
• The paint is sensitive to light. The container must therefore be closed immediately after use.
• Particular safety conditions must be complied with when operating the mobile UV lamp. Work areas must be clearly marked out for everyone to see and / or cordoned off. Danger of eye damage caused by UV light.
• The use of special Visiere goggles is required due to the risk of eye damage.
• Skin must be fully covered with clothing.
• The surface must be professionally sanded. The floor must be dry and free of any old coatings, oil, grease, wax, silicone, sanding dust and other impurities.
• The optimal processing conditions are room temperature +15°C to + 25°C, floor temperature +15°C to +22°C, rel. humidity 40% - 75%, material temperature +18°C - + 25°C, max. wood moisture 12%, sufficiently ventilate working rooms.
• In order to prevent parquet damage, the room temperature should be set to the annual average expected for the use of the product.
• To reduce the risk of excessive swelling, we recommend applying a maximum of 2 roll applications per day.
• Transfer material to a LOBA varnish bucket before applying.
• Shake the contents well.
• Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.

Thinner / Mixing

The product is ready for use and must not be reduced!

Application tool / application rate

LOBA roller Universal 100 / 100ml(g)/m² = 10m²/l(kg).
Curing: Mobile UV lamp e.g. DecoRad® Floormate.

Drying time

• Can be carefully walked on and hardened and intermediate sanding can be performed after no less than 2 hours.
• Full traffic capability and coverage immediately after UV curing.
• Drying times are valid for +20°C and 50% relative humidity.

Intermediate sanding

Use LOBASAND perforated pad P120 or finer, alternatively Sanding Net P120 or finer.The surface can only be varnished over following an intermediate sanding.Carefully remove dust before overcoating.

Application for parquet and wooden flooring:

• Prepare the substrate properly and prime with LOBA EasyPrime (1x rolled).
• Drying of the base as prescribed (1-2 hours)
• Roll on finish.
• Drying.
• Cure with a mobile UV lamp.
• Intermediate sanding.
• Roll on a second layer of finish.
• Drying.
• Cure with a mobile UV lamp.

Suitable product combinations

We recommend using a primer:

to minimise side bonding and to seal off wood constituents, e.g. in exotic timber.

• EasyPrime.