• Shake the contents well.
• Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.

Thinner / Mixing

Water.

Application tool / application rate

LOBA spray can or wiper mop / 10-20ml/m² = 50-100m²/l (equivalent to 1-2l per 100m² with ready-to-use mixture) depending on the degree of soiling. Cleaning with a single-disc machine and LOBASAND SpecialPad green or a scourer-vacuum machine with suitable pads.

Application:

Preparation:

Mix stripper in a ratio of 1:4 to 1:6 with water and wet the surface using a LOBA spray can or a wiper mop.

Stripping (cleaning machine) on medium to large areas:

After allowing the product to work for a short while, use a scourer-vacuum machine with suitable abrasive pad discs and vacuum up the resulting dirt immediately.

Stripping (single-disc machine) on small to medium-sized areas:

After allowing the product to work for a short while, clean the surface with a single-disc machine with LOBASAND SpecialPad green underneath. Vacuum up the resulting dirt immediately with a wet vacuum cleaner or use cloths or wiper mops to soak it up.

Stripping (manual) on small areas:

Apply the cleaning fluid and, after a short while, clean the floor manually using a scrubber with a medium-hardness brush. Vacuum up the resulting dirt immediately with a wet vacuum cleaner or use cloths or wiper mops to soak it up.

Initial care:

After every strip, a further initial care step is required with a suitable LOBA care product. The care product must only be applied when the flooring is completely dry.

Intensive Cleaning

Stubborn stains and footprints that cannot be removed with LOBA SportCleaner can in many cases be removed by cleaning with SportRemover diluted 1:10 with water. When using this solution, damp-clean the floor using a mop suitable for the type of flooring. Immediately afterward, damp-wipe again with clean water to neutralize. Treat stubborn dirt with a cloth, a brush, or a green LOBASAND SpecialPad and single-disc machine (using more abrasive pads, sponges, etc. may scratch the surface). Before full-surface application, spot-test suitability for certain types of soiling. Stains that have penetrated or permeated the varnish cannot be removed without leaving residues.

Important information

Where there is a heavy build-up of care products, the process may also need to be repeated several times. To finish, wipe over the surface with clean water and neutralise. This can also be done by machine.