• The cement-based leveling compound must be prepared for direct use according to the manufacturer's instructions.
• Shake the mixture, add the hardener in a ratio of 10:1 and mix in by shaking. If partial quantities are to be mixed, use the LOBA mixing container or weigh the quantities out. Can be used for one hour after mixing.
• The floor must be dry and free of any previous layers, oil, grease, wax, silicone or any other impurities. Optimum working conditions: room temperature of +15°C - +25°C, floor temperature of +15°C - +22°C, 40% - 75% relative humidity, material temperature of +18°C - +25°C. Working areas must be adequately ventilated.
• Transfer material to a LOBA varnish bucket before applying.
• Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.
• This product is part of the LOBA and Wakol "Connected Systems" for finishing cementitious levelling compounds. The approved combinations can be found at www.loba.de/en/products/connected-systems/levelling-compounds.
• Shake the contents well.

Thinner / Mixing

The product is ready for use and must not be reduced!

Application tool / application rate

LOBA roller Microfiber 100-120 / approx. 100 ml(g)/m² = 10m²/l(kg)

Drying time

• Can be carefully walked on after no less than 4 hours.
• Light use after 24 hours.
• Full use and covering possible after 5 days.
• The floor can be covered earlier by using LOBA Cover 400, for details see the TI for the product.
• Drying times are valid for +20°C and 50% relative humidity.

Application:

Preparation:

• Apply suitable cementitious levelling compound for direct use according to the manufacturer's instructions. Do not sand the leveling compound, any inclusions should be partially removed with a sharp blade.
• Suitable levelling compounds can be found on the list of approved cementitious levelling compounds at: www.loba.de/en/Suitability-list/Factory-Line. Regard respective technical information of the levelling compound manufacturer.
  

Application:

• Prepare the substrate professionally and prime with FactoryBase, according to technical information.
• Allow the primer to dry for at least 3 hours, wait until completely dry.
• Roll on one coat of finish.
  For further details please refer to "Set-up recommendation levelling compound as accessible surface | finished".

Care instruction to maintain surface:

Detailed recommendations for cleaning and care can be found in the LOBA care instructions "finished cementitious levelling compounds". These general and product-specific recommendations can also be found under www.loba.de.

Important information

Mechanical resistance:

• Resistant to mild grinding and rolling load.
  

Liquids:

• A finished system set-up is a system open to diffusion.
• Liquids are to be absorbed immediately, as prolonged exposure can lead to discoloration.
• If film injuries (scratches, holes, cuts, etc.) occur, liquids can be absorbed unhindered into the filler.
• Depending on the inherent color of the levelling compound or the surface coating, contaminations become more visible, e.g. dark coffee stain on light levelling compound.

Only step on unfinished levelling compound with shoe covers. Dirt and moisture acting on the levelling compound, may become visible after surface treatment.