• Stir the mixture, add the hardener in a ratio of 10:1 and stir in well (also possible by machine with LOBA Paint mixer). If partial quantities are to be mixed, these must be weighed out. After mixing, transparent oil can be used for 2 hours while color oil can be used for 1 hour.
• The surface must be professionally sanded. The floor must be dry and free of any old coatings, oil, grease, wax, silicone, sanding dust and other impurities.
• The optimal processing conditions are room temperature +15°C to + 25°C, floor temperature +15°C to +22°C, rel. humidity 40% - 65%, material temperature +18°C - + 25°C, max. wood moisture 12%, sufficiently ventilate working rooms.
• In order to prevent parquet damage, the room temperature should be set to the annual average expected for the use of the product.
• Transfer material to a LOBA varnish bucket before applying.
• Shake the contents well.
• Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.
• This product is part of the LOBA and Wakol “Connected Systems”. The approved combinations with Wakol parquet adhesives may be found in the "Connected Systems" Matrix: www.loba.de/connected-systems

Thinner / Mixing

The product is ready for use and must not be reduced!

Application tool / application rate

LOBA oil roller Microfaser 60-80 / 30-60 ml (g)/m2, depending on the absorbency of the substrate. Equalise with LOBASAND SpecialPad beige.

Drying time

• Can be walked on after 12 hours.
• Light stress after 24 hours.
• Coverage after 5 days.
• The floor can be covered earlier by using LOBA Cover 400, for details see the TI for the product.

Roller application:

• Prepare the substrate.
• Apply a thin layer of oil using the LOBA oil roller Microfaser 60-80.
• Allow to work for around 1 hour.
• Equalise with the single-disc machine and the LOBASAND SpecialPad beige underneath.

Use on levelling compound WAKOL Z 610, WAKOL Z 615 and WAKOL Z 625:

Preparation:

• Apply WAKOL Z 610, WAKOL Z 615 or WAKOL Z 625 levelling compound directly according to manufactorers instructions, regard technical information.
• Do not sand levelling compound, remove possible inclussions partially with a sharp blade.
  

Application oiled/waxed surface:

• Apply LOBA 2K ImpactOil thinly with LOBA Oil roller 60-80, consumption approx. 80 g/m².
• Immediately even out residues with a LOBA special-Pad beige.
• Drying over night.
• Apply LOBA Akzent 100 Wax with a LOBA trowel, work in sections (approx. 20 g/m²).
• Immediately even out residues with a LOBA special-Pad beige.
  
  For further details please regard "Set-up recommendation levelling compound as accessible surface | oiled".

Important information

Not approved for spray application.Excess material must be completely removed during equalisation. Drying delays are possible on some exotic timbers.Keep soaked cloths, pads and other tools in closed containers. Moisten oil in combination with sanding dust, fabric cloths and so on with water or store in a sealable bucket and dispose of in a fire-safe manner, since otherwise there is a risk of self-ignition.Trowel applications are only possible with joint-sealed wooden flooring. Oil that penetrates joints will not dry completely over a long period.