• Shake the mixture, add the hardener in a ratio of 2: 1 and mix in by shaking. If partial quantities are to be mixed, these must be weighed out. Can be used for 2 hours after mixing.
• Shake the contents well.
• Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.

Thinner / Mixing

Application tool / application rate

Drying time

• Earliest possible overcoating after 2 hours.
• However within 24 hours.

Setup recommentdation for UV-finished parquet surfaces:

• Perform basic cleaning with single disc machine, underlayed LOBA special-pad green and LOBA CareRemover 1:4.
• Remove disolved dirt with a water vacuum cleaner and neutralise with clear water or use a scourer-vacuum machine.
• Allow the surface to dry sufficiently.
  
Newly installed surface,
Consult LOBA technical department to check suitability for re-coating. If necessary establish test area and perform adhesion test.

Application of 2K Contact:

• Apply one coat of 2K Contact.
• Once dry and tack-free (approx. 2 hours), varnish with 2K Supra A.T. or 2K Duo (non-glossy)