• Remove loose dirt and dust in advance with a vacuum, broom or mop, then damp-wipe the surface with LOBA CleanFix or Cleaner. Stubborn dirt or care product residue must be removed in advance by stripping the surface with LOBA CareRemover. Please note the relevant product's technical information when doing this.
• Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.
• Shake the contents well.

Thinner / Mixing

The product is ready for use and must not be reduced!

Application tool / application rate

LOBA Wischwiesel, on large areas with a suitable flat wiper mop / 30-40 ml(g)/m2 = 25-35m2/l(kg) = 3-4 l/100 m2

Drying time

• Can be walked on after 1-2 hours.
• Full traffic capability and coverage after 12 hours.

Application:

Material is pre-applied to the flooring in sections and then applied in an even layer. Lay the applicator as flat as possible on the floor and do not lift. Do not use pressure. Start at one side of the room and then work from wall to wall towards the opposite side of the room with the exit door. A room should always be completely treated in one go. Never rework the floor while it is drying since this can lead to streak formation.

Stripping:

PermanentCare cannot be permanently removed from finished parquet, wood or cork flooring and linoleum by stripping.
Bonding defects may occur on newly laid factory finished elements. In this case, preliminary tests are essential. Prior stripping with LOBA CareRemover in many cases results in adequate adhesion.