• Shake the contents well.
• Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.

Thinner / Mixing

The product is ready for use and must not be reduced!

Application tool / application rate

LOBA spray can or cloth / 10-30 ml/m² (30-100m²/l), depending on the absorbency of the substrate.

Drying time

• Careful use possible after 4-6 hours.
• Full traffic capability and coverage after 12 hours.

Application:

Newly laid multi-layer elements, as well as freshly oiled flooring

must be cleaned until it is free from dust (brush, vacuum). Apply NatureOil in a thin even layer with a lint-free cloth, equalising any excess immediately until a completely transparent surface is produced. Avoid puddle formation.

Floors with stubborn dirt and worn floors with traces of use

can be prepared with a thorough cleaning using LOBA Cleaner or LOBA ParkettSoap, if necessary also with mechanical equalisation using slightly abrasive LOBASAND SpecialPads (beige/green). After drying completely, apply NatureOil.

For more serious damage,

treatment with an impregnating oil may be necessary. We provide information about this in the LOBA care instructions for oiled wooden flooring.

Larger areas

can be treated using the SprayCleaner method. Apply NatureOil by spraying it on and equalising it by machine (single-disc machine with LOBASAND SpecialPad white).

On non-absorbent substrates

e.g. newly laid or barely used parquet flooring UV-oiled at the factory, wetting problems can occur. NatureWax, for example, is suitable for caring these floors.

Important information

Keep soaked cloths, pads and other tools in closed containers. Moisten oil in combination with sanding dust, fabric cloths and so on with water or store in a sealable bucket and dispose of in a fire-safe manner, since otherwise there is a risk of self-ignition.